Selected DR.BOAT 2 IN 1 ADHESIVE FOR PVC Pontoons and Pools (liquid glue and patch) with the effect of cold welding + free reinforcing mesh.
Why choose DR. Boat over other adhesives?:
The glue is specialized.
The formula of the adhesive is designed in such a way that it can be used to repair items used both in fresh and salt water.
You can use it as a standard glue for sticking patches or as a liquid patch.
During gluing, it does not require the use of hardeners and heating.
After drying, it retains the strength and flexibility of the glued object.
It is durable and flexible.
The glue is transparent and can be used to repair items of different colors.
Brief instructions for use:
Using in conjunction with a patch:
Carefully degrease the glued surfaces.
Next, lubricate the patch and the glued object with a thin layer of glue.
Then put the patch on the glued object, press and hold for 1 minute.
The minimum drying time is 6 hours, but it is best to wait 24 hours.
Using without a patch:
Degrease the damaged area.
The glued object should be secured against moving (e.g. with clamps).
Apply a thick layer of glue to the damaged area 1 cm larger than the damage in all directions.
Wait 20 minutes.
Apply a second thick layer.
After 5 hours, remove the clamps.
After 24 hours, the glued object can be used.
In case of larger damage (cuts more than 3 cm), carry out the repair using a reinforcing mesh, which comes with the glue.
Prepare a mesh 2 cm larger than the damaged area.
Thoroughly degrease the surface.
Apply glue to the damaged area and press it into the mesh.
After 20 minutes, apply the glue again on the surface 1.5 cm larger than the previous layer.
The glued area becomes sufficiently strong after 24 hours
DR.BOAT- is a product capable of removing, down to the molecular level, virtually any defect caused by a PVC tissue product.
Vulcanization (monolith with the product),
The original properties of the material base are preserved.
The product won’t freeze at relatively negative temperatures, but avoid repairing your product at low temperatures.
Reinforcing mesh, 20 cm long and 5 cm wide. Used for reinforcements or repairs together with Liquid Patch PVC, Liquid PVC Ulow, Dr. Boat etc. We recommend that you use this mesh when repairing cuts or holes over 2 cm.
Directions for use:
1) Clean and grease the damaged area.
2) Put on the mesh.
3) Apply a layer of liquid PVC on top. It is important to apply the liquid PVC wider by min. 1 cm than the edges of the mesh on each side. You should also wait a few hours after the repair before using the equipment you are repairing. The mesh will form a uniform layer with liquid PVC and the repaired area will be strengthened beyond the original strength of the equipment.
There is currently no comments or ratings for this product.