Set of 2 x Fin Stabilizers (Attach with included adhesive) + Professional 2in1 PVC adhesive Dr. Boat

Set of 2 x Fin Stabilizers (Attach with included adhesive) + Professional 2in1 PVC adhesive Dr. Boat

Stabilizer Fins can be Glued to Pontoons to increased stability in the water. 

The fins stick either side at the rear of the pontoon.

 Provides greater stability and significantly reduces turning radius.

Additionally, fins protect your pontoon against tearing and abrasion while mooring to the shore or pulling it out of the water.

Technical specifications:

Length ~ 20 cm

Width ~ 6 cm

Height ~ 4.5 cm

Professional 2-in-1 PVC adhesive for DR.BOAT swimming pools and inflatable boats

DR.BOAT 2 IN 1 Specialized ADHESIVE FOR PVC Pontoons and Pools (liquid glue and patch) with cold welding effect.

EFFECTIVE ADHESIVE FOR PONTOONS, POOLS AND OTHER PVC PRODUCTS.

We offer an innovative and specialized new adhesive for the repair of PVC products. It can be used to glue pontoons, swimming pools, tarpaulins, etc.

Why choose DR. Boat over other adhesives?:

The glue is specialized.

The formula of the adhesive is designed in such a way that it can be used to repair items used both in fresh and salt water.

You can use it as a standard glue for sticking patches or as a liquid patch.

During gluing, it does not require the use of hardeners and heating.

After drying, it retains the strength and flexibility of the glued object.

It is durable and flexible.

The glue is transparent and can be used to repair items of different colors.

Brief instructions for use:

Using in conjunction with a patch:

Carefully degrease the glued surfaces. Next, lubricate the patch and the glued object with a thin layer of glue. Then put the patch on the glued object, press and hold for 1 minute. The minimum drying time is 6 hours, but it is best to wait 24 hours.

Using without a patch:

• Degrease the damaged area.
• The glued object should be secured against moving (e.g. with clamps).
• Apply a thick layer of glue to the damaged area 1 cm larger than the damage in all directions.
• Wait 20 minutes.
• Apply a second thick layer.
• After 5 hours, remove the clamps. 
• After 24 hours, the glued object can be used.

In case of larger damage (cuts more than 3 cm), carry out the repair using a reinforcing mesh, which comes with the glue. 

• Prepare a mesh 2 cm larger than the damaged area. 
• Thoroughly degrease the surface. 
• Apply glue to the damaged area and press it into the mesh. 
• After 20 minutes, apply the glue again on the surface 1.5 cm larger than the previous layer. The glued area becomes sufficiently strong after 24 hours

DR.BOAT - is a product capable of removing, down to the molecular level, virtually any defect caused by a PVC tissue product.

High adhesion,

UV resistant,

Vulcanization (monolith with the product),

Elastic,

The original properties of the material base are preserved.

The product won’t freeze at relatively negative temperatures, but avoid repairing your product at low temperatures.